How to Make the Most of Your Auger Bits

With a couple of small details, auger bits can cut deep holes in wood with little effort required from the user. Here are some tips to make most of your auger bits:

• Setting up A guide screw on an auger bit The guide screw on an auger bit is handy. It assists in drilling accurate holes and pulls the bit through the workpiece, reducing the quantity of pressure that must be applied to the drill. However, it is often a hindrance to drilling within the wrong circumstances and may bite into the workpiece too aggressively, causing it to spin or causing damage to the drilling bit.  

• A plane with a propeller, for instance, what your workpiece will appear as if the auger bit bites onto it and it is not clamped down. If you mean to use an auger bit on a drill press, use touch with a gimlet point instead of a guide screw wherever possible. Otherwise, confirm you clamp your workpiece right down to prevent it from spinning sort of a propeller on the top of your auger bit.
  
  
• Auger bits are wide enough and long enough for the task you are trying to complete. Make sure you select a touch with the proper diameter for your project and is long enough to drill the depth of the hole you're trying to find. 
  

Read More: What is Auger Bit and its types

Drilling The Opening 

Step 1 – Secure workpiece

Make sure your workpiece is secured during a vice or clamped to your drill press table.

Locate the auger bit on the center mark of their proposed borehole before they begin the drilling process. 

Step 2 – Align Drilling Bit

Line up the center of your guide screw, or gimlet point, with the purpose where you would like to bore your hole. If you're employing a barefoot auger, you'll get to do that by eye (you will attempt to locate the mark underneath the center point of the drilling bit as best as possible).

Step 3 – Activate Drill

With the bit in touch together with your workpiece, activate your drill (or begin turning if you're employing a hand brace). The guide screw of your bit will enter the workpiece, and therefore the bit will start the boring process.

Don't apply an excessive amount of pressure when drilling with an auger bit. Don't use an excessive amount of downward pressure. You ought to not rest on the bit or down as you drill because the drill bit will effectively pull itself through the workpiece on its own. 

Instruction to withdraw the drill bits from the opening while it's still spinning so that it creates a clean borehole 

Step 4 – Withdraw Bit

Once you've got drilled through your hole, activate your drill again as you remove the drill bit from the opening. It may clear the flighting of any remaining excelsior because it is withdrawn.